How To Wire Car Audio Amplifier (In Home) NVX JAD1200.1 Bass Amp & Crescendo LOGIC 12V AGM Battery

  • This video will demonstrate how simple it is hooking up a car audio amplifier, whether your outside installing in your ride, or lounging out getting loud indoors! These little NVX amps are great for this kind of thing, given they are so small, and draw so little current - THANKS FOR WATCHING :)
    CLICK HERE For More Info!
    Check Out More NVX Audio Gear at Sonic!
    JAD 1200.1 Bass AMP
    Amplifier Series: JAD (NVX)
    Amplifier Class: D
    Number of Channels: 1 - Mono
    Total RMS Power Output
    1200 watts
    Input Gauge Size: 1/0 AWG
    Minimum Impedance Unbridged: 1 ohms
    Preamp Outputs
    Built-in Crossover
    Low-Pass Crossover Frequency: 40 - 320 Hz
    Subsonic Filter: 20 - 38 Hz
    Signal-to-Noise Ratio: 111 dB
    Bass Remote
    Fuse Rating
    40A x 3
    CEA-2006 Compliant
    Strappable: Yes
    Step 1: Mount Amplifier In Safe Location
    Step 2: Run Ground Wire From NEGATIVE Post Of Battery to NEGATIVE Terminal of Amplifier Power Input
    Step 3: Run Power Wire From POSTIVE Post of Battery to POSITIVE Terminal of Amplifier Power Input
    Step 4: Run Remote Wire From POSITIVE Toggle Switch, Remote Out, or Ignition Switch to REMOTE Input on Amplifier
    Step 5: TEST Amp, Turn Power On
    Step 6: Run Speaker Wires & Connect To Respective NEGATIVE & POSITIVE Speaker Terminals on Amplifier
    Step 7: Run RCA Wires From Music Source (MP3 Player, IPOD, Head Unit ect)
    Step 8: Adjust Filters / Settings (Gain, LPF, Subsonic Filter)
    CLICK BELOW For Detailed Information On Tuning!
    Step 9: ENJOY THE BASS! :)
    Bassheads Unite 2014

    Category : Doublsmm


    0 Comments and 0 replies